Ethedeal Visual Dog Artificial Insemination Gun Kit,Dog Veterinary Breeding Kit,Dog Visual Endoscope Breeding Kit,with 5MP Camera Rotatable Screen (Small)

The built-in air valve is used to purge the camera to remove water vapor or mucus stuck on the camera due to temperature difference. The display screen can be rotated 120 ° up and down, about 360 ° around, to easily watch the conveying process and facilitate teaching and discussion. It breaks through the barrier that traditional products do not exceed 3 hours, with longer standby time and no worries for continuous operation. Video recording, photographing, playback, image amplification, image output and printing, clearly record every moment. Before holding the handle, put on the wrist strap. The insemination gun is not easy to fall off, and the conveying process is more reassuring. Medical material, more reassuring to use, round head design, no harm to the uterus, more safe insemination. The ultra-high definition screen is selected, which can be compatible with strong light, dark, cold, dry, hot and humid working environments. Total length: 340mm Probe rod length: 250mm Probe rod diameter: 10 mm Handle width: 80mm Diameter of expansion head: 12mm Expansion head length: 7mm Air passage diameter: 1 mm Diameter of insemination channel: 3mm Screen size: 3.5 inches Resolution: 640x480 (1) Wipe the probe and probe rod of the visual insemination gun with alcohol cotton ball, install the front expansion head, and insert the positioning steel needle into the insemination needle. (2) When the dog is in an inverted or semi-inverted state, insert the probe rod of the visible insemination gun into the genital tract until it cannot be inserted. (3) Slowly back up the insemination gun. If the screen is blurred, you can press the pneumatic button of the handle. Blow off the cover of the camera. (4) See the position of the uterine orifice, insert the insemination needle from the rear end of the visible insemination gun to observe the change of the display, and fine-tune the direction to let the insemination needle enter through the fold gap of the uterine orifice, about 4 cm. (5) Pull out the positioning steel needle, connect the insemination needle with the syringe containing semen, and conduct the insemination slowly, with the use of no more than 1.5 ML gas will push the semen inside the final insemination needle. (6) Pull out the insemination needle, withdraw the visible insemination gun, stand upside down for a few minutes, and complete the insemination.